With regard to the three common faults and cause analysis of the belt of the capping machine, I hope that it can help everyone quickly find out the cause and make adjustments when encountering a belt fault, so that the belt can run better!
One: the bottle is dumped
1) The center of the belt and the center of the capping wheel are not on the same straight line
2) The speed of the conveyor belt and the speed of the capping machine belt are not synchronized
3) The belt is too loose or the tightening torque is large
4) The upper and lower distance of the belt is too small
2: The cap is not tightened
1) The bottle goes too fast when screwing the cap
2) The belt tightening torque is too small or the rubbing wheel speed is too slow
Three: the bottle cap is twisted
1) Damage to the rubbing wheel or belt
2) The radial contact surface between the rubbing wheel and the cover is too small
3) The screw of the bottle cap or bottle mouth is deformed or damaged
English
